%{tishi_zhanwei}%

Yuanlei | Kaolin Series-Calcined Kaolin (Special for Rubber and Filler)

Release time:

2024-01-29 09:37

 

Yuanlei | Kaolin Series-Calcined Kaolin (Special for Rubber and Filler)

 

Calcined kaolin (special for rubber and filler)

 

Performance:Kaolin is a non-metallic mineral, which is a kind of clay and clay rock mainly composed of kaolinite clay minerals. Because it is white and delicate, also known as white earth.

 

Features:Due to the high purity of kaolinite, the content of harmful elements is very low, so not only the treatment process is simple, but also the whiteness of the product is high, the average whiteness can reach 93%, the highest whiteness can reach 97%, used in papermaking can improve the whiteness of coated paper, instead of some titanium dioxide, can reduce costs. The viscosity concentration is high, up to 74%, the dispersion is good, the covering rate is strong, and it has good compatibility with natural and synthetic adhesives and other additives in the formula, which can make the coating have good rheological properties, especially suitable for coating machine with high solid content. The abrasion value is low, the material is heated evenly, and local over-burning will never occur. The tested abrasion value is only 3.6mg/2000 times.

 

Scope of application:Suitable for high-grade paint, paint, ink, rubber, plastic, wire and cable, etc.

1. Papermaking, coating can replace some expensive titanium dioxide.

2. Paint, water-based latex coatings.

3. Rubber and special cable reinforcing agent, industrial plastic functional filler, ink, food, medicine, cosmetics filler.

4. Advanced porcelain and special ceramic raw materials.

 

Kaolin, paint, filler, rubber, clay, ink, content, part, abrasion

Yuan Lei's Little Knowledge | Application of Wet Mica Powder in Rubber

2024-06-19


Wet mica powder is widely used, not only in coatings but also in rubber. Below, the editor will take you to understand the application of wet mica in rubber.

Yuan Lei's Little Knowledge | Performance Requirements and Types of Fillers for Coatings

2024-06-12


Fillers in coatings are usually white or slightly colored pigments with a refractive index less than 1.7. It has the basic physical and chemical properties of pigments used in coatings, but due to its refractive index being similar to the film-forming material, it is transparent in coatings and does not have the coloring and covering power of coloring pigments. It is an indispensable pigment in coatings.

Yuan Lei's Little Knowledge | Application Effects of Different Mineral Powder Materials in Coatings

2024-06-04


In architectural coatings, commonly used mineral materials include barium sulfate, calcium carbonate, kaolin, mica powder, talc powder, quartz powder, silica micro powder, transparent powder, glass powder, wollastonite powder, etc. Reasonable application of various mineral materials can effectively improve or enhance the performance of coatings. Let's take a look at the application of different mineral materials in coatings.