%{tishi_zhanwei}%

Yuan Lei tells you the role of barium sulfate in improving the powder rate of powder coatings.

Release time:

2024-01-29 09:34

1. control powder particle size distribution, the narrower the better:Reasonable control of powder particle size (more difficult), in our actual production only to adjust the ACM main and auxiliary mill speed. Powder particle size is important 40-50UM is appropriate, the distribution of about narrow the better.

2. increase resin content:Increase the amount of resin and reduce the amount of filler. Select resin with good charging performance. Epoxy is better to powder. Some manufacturers do not powder polyester. Some manufacturers do not powder polyester. Some manufacturers do not powder polyester (grinding epoxy and polyester into powder spraying board separately). The leveling sprayed by friction spray gun is obviously better than that of electrostatic spray gun. Moreover, friction spray gun can spray thicker coating. The coating does not have the disadvantages of high pressure gun such as big orange peel.

3.Reasonable choice of filler:Filler fineness and dispersion are closely related to the powder. Precipitation on the powder is higher than the general ultrafine heavy barium, barium sulfate is better than calcium carbonate.

4. increase charged auxiliaries:Appropriate amount of conductive additives are added to the formula (mechanism of action: the powder particles can be charged with more charge. There is a strong electric field in the area from the high-voltage electrostatic spray gun to the workpiece, and the air is ionized to produce hundreds of millions of ions. When the powder particles of the electric booster pass through this area, they are polarized, which can trap more negative ions and carry more charge. For the groove dead angle and other parts due to the weak power line of the Faraday effect, the powder particles with more charge can reach the surface of the workpiece by their own strength, thus improving the powder on these parts.

 

Barium sulfate, powder, resin, polyester, filler, more, charge, particle, improve, better

Yuan Lei's Little Knowledge | Application of Wet Mica Powder in Rubber

2024-06-19


Wet mica powder is widely used, not only in coatings but also in rubber. Below, the editor will take you to understand the application of wet mica in rubber.

Yuan Lei's Little Knowledge | Performance Requirements and Types of Fillers for Coatings

2024-06-12


Fillers in coatings are usually white or slightly colored pigments with a refractive index less than 1.7. It has the basic physical and chemical properties of pigments used in coatings, but due to its refractive index being similar to the film-forming material, it is transparent in coatings and does not have the coloring and covering power of coloring pigments. It is an indispensable pigment in coatings.

Yuan Lei's Little Knowledge | Application Effects of Different Mineral Powder Materials in Coatings

2024-06-04


In architectural coatings, commonly used mineral materials include barium sulfate, calcium carbonate, kaolin, mica powder, talc powder, quartz powder, silica micro powder, transparent powder, glass powder, wollastonite powder, etc. Reasonable application of various mineral materials can effectively improve or enhance the performance of coatings. Let's take a look at the application of different mineral materials in coatings.